Compressor HVAC: Adjustments
LUBRICANTName: Nissan A/C System Oil Type R
Part number: KLH00-PAGR0
Lubricant Adjustment Procedure for Compressor Replacement
1. Before connecting ACR4 to vehicle, check ACR4 gauges. No refrigerant pressure should be displayed.
If OK, recover refrigerant from equipment lines.
2. Confirm refrigerant purity in supply tank using ACR4 and refrigerant identifier.
If NG, refer to "Contaminated Refrigerant".
Contaminated Refrigerant
3. Connect ACR4 to vehicle. Confirm refrigerant purity in vehicle A/C system using ACR4 and refrigerant identifier.
If NG, refer to "Contaminated Refrigerant".
Contaminated Refrigerant
4. Discharge refrigerant into the refrigerant recovery/recycling equipment. Measure lubricant discharged into the recovery/recycling equipment.
5. Drain the lubricant from the old (removed) compressor into a graduated container and recover the amount of lubricant drained.
6. Drain the lubricant from the new compressor into a separate, clean container.
7. Measure an amount of new lubricant installed equal to amount drained from old compressor. Add this lubricant to new compressor through the suction port opening.
8. Measure an amount of new lubricant equal to the amount recovered during discharging. Add this lubricant to new compressor through the suction port opening.
9. If the liquid tank also needs to be replaced, add an additional 5 ml (0.2 US fl oz, 0.2 Imp fl oz) of lubricant at this time.
Do not add this 5 ml (0.2 US fl oz, 0.2 Imp fl oz) of lubricant if only replacing the compressor.