A/T Does Not Shift: D3->D4

11. A/T Does Not Shift: D3 -> D4

SYMPTOM:
- A/T does not shift from D3 to D4 at the specified speed.
- A/T must be warm before D3 to D4 shift will occur.

1. CHECK SYMPTOM
Are "7. Vehicle Does Not Creep Forward In D, 2 Or 1 Position" and "8. Vehicle Cannot Be Started From D1 " OK?
Yes or No
Yes >>GO TO 2.
No >> Go to "7. Vehicle Does Not Creep Forward in D, 2 or 1 Position" and "8. Vehicle Cannot Be Started From D1".

2. CHECK SELF-DIAGNOSTIC RESULTS
With CONSULT-II





Does self-diagnosis, after cruise test, show damage to any of the following circuits?
- Park/neutral position (PNP) switch
- Overdrive control switch
- A/T fluid temperature sensor
- Vehicle speed sensor A/T (revolution sensor)
- Shift solenoid valve A or B
- Vehicle speed sensor MTR
Yes or No
Yes >> Check damaged circuit. Refer to "DTC P0705 PARK/NEUTRAL POSITION SWITCH", "DTC P0710 A/T FLUID TEMPERATURE SENSOR CIRCUIT", "DTC P0720 VEHICLE SPEED SENSOR A/T (REVOLUTION SENSOR)", "DTC P0750 SHIFT SOLENOID VALVE A", "DTC P0755 SHIFT SOLENOID VALVE B", or "DTC VEHICLE SPEED SENSOR MTR".
No >> GO TO 3.

3. CHECK THROTTLE POSITION SENSOR [ACCELERATOR PEDAL POSITION (APP) SENSOR]





Check throttle position sensor [accelerator pedal position (APP) sensor].
OK or NG
OK >>GO TO 4.
NG >> Repair or replace throttle position sensor [accelerator pedal position (APP) sensor].

4. CHECK A/T FLUID CONDITION





1. Remove oil pan.
2. Check A/T fluid condition.
OK or NG
OK >> GO TO 6.
NG >> GO TO 5.

5. DETECT MALFUNCTIONING ITEM
1. Remove control valve assembly.
2. Check the following items:
- Shift valve B
- Overrun clutch control valve
- Shift solenoid valve B
- Pilot valve
- Pilot filter
3. Disassemble A/T.
3. Check the following items:
- Servo piston assembly
- Brake band
- Torque converter
- Oil pump assembly
OK or NG
OK >> GO TO 7.
NG >> Repair or replace damaged parts.

6. DETECT MALFUNCTIONING ITEM
1. Remove control valve assembly.
2. Check the following items:
- Shift valve B
- Overrun clutch control valve
- Shift solenoid valve B
- Pilot valve
- Pilot filter
OK or NG
OK >> GO TO 7.
NG >> Repair or replace damaged parts.

7. CHECK SYMPTOM
Check again. OK or NG
OK >> INSPECTION END
NG >> GO TO 8.

8. CHECK TCM INSPECTION
1. Perform TCM input/output signal inspection.
2. If NG, recheck TCM pin terminals for damage or loose connection with harness connector.
OK or NG
OK >> INSPECTION END
NG >> Repair or replace damaged parts.