RS5F51A

SIDE OIL SEAL
Removal and Installation
REMOVAL





1. Remove the drive shaft from the transaxle body.
2. Remove oil seal with a slotted screwdriver.

CAUTION: Be careful not to damage the case surface when removing the oil seal.

INSTALLATION





Dimension A : Within 0.5 mm (0.02 in) or flush with the case.

1. Using a drift (special service tool), drive the oil seal straight until it protrudes from the case end equal to dimension A shown in the figure.





Drift to be used:

CAUTION:

- When installing oil seals, apply multi-purpose grease to oil seal lips.
- Oil seals are not reusable. Never reuse them.

2. Installation is in the reverse order of removal. Check oil level after installation.