RS6F51H

FINAL DRIVE
DISASSEMBLY
1. Remove mounting bolts. Then, separate the final gear from differential case.
2. Remove speedometer drive gear.





3. Using a drift and puller, remove differential side bearing (clutch housing side).





4. Using a drift and puller, remove differential side bearing (transaxle case side).

INSPECTION AFTER DISASSEMBLY
Bearing





- Check for bearing damage and rough rotation. If necessary, replace with a new one.

CAUTION: When replacing tapered roller bearing, replace outer and inner races as a set.

ASSEMBLY





1. Using a drift (special service tool), install differential side bearing (transaxle case side).





2. Align and install speedometer drive gear onto differential case.





3. Using a drift (special service tool), install differential side bearing (clutch housing side).





4. Install differential gear into differential case, and tighten final gear mounting bolts.