Operation

REMOTE KEYLESS ENTRY SYSTEM

Operating Function Of Hazard and Horn Reminder:

How to change hazard and horn reminder mode
With CONSULT-II
Hazard and horn reminder can be changed using "WORK SUPPORT" mode in "MULTI REMOTE ENT".






Without CONSULT-II
When LOCK and UNLOCK signals are sent from the keyfob for more than 2 seconds at the same time, the hazard and horn reminder mode is changed and hazard warning lamp flashes and horn sounds as follows:



Interior Lamp Operation
When the following input signals are both supplied:
- front door switch LH CLOSED (when driver door is closed);
- driver door LOCKED;
remote keyless entry system turns on interior lamp (for 30 seconds) with input of UNLOCK signal from keyfob.
For detailed description, refer to "INTERIOR, MAP, VANITY AND TRUNK ROOM LAMPS".


Panic Alarm Operation
When key switch is OFF (when ignition key is not inserted in key cylinder), remote keyless entry system turns on and off horn and headlamp intermittently with input of PANIC ALARM signal from keyfob.

The alarm automatically turns off after 25 seconds or when smart entrance control unit receives any signal from keyfob.



Trunk Lid Operation
Power is supplied at all times:
- through 10 A fuse [No. 6, located in the fuse block (J/B)]
- to trunk lid opener actuator terminal +.

When a TRUNK OPEN signal is sent with key OFF (ignition key removed from key cylinder) from keyfob, ground is supplied:
- to trunk lid opener actuator terminal -
- through smart entrance control unit terminal 12.

Then power and ground are supplied, trunk lid opener actuator opens trunk lid.