Engine Lubrication: Service Precautions
Precautions for Liquid GasketREMOVAL OF LIQUID GASKET SEALING
^ After removing the mounting bolts and nuts, disconnect and remove the RTV Silicone Sealant using a seal cutter.
CAUTION: Be careful not to damage the mating surfaces.
^ In areas where the cutter is difficult to use, use a plastic hammer to lightly tap the areas where the RTV Silicone Sealant is applied.
CAUTION: If for some unavoidable reason a tool such as a flat-bladed screwdriver is used, be careful not to damage the mating surfaces.
LIQUID GASKET APPLICATION PROCEDURE
1. Using a scraper, remove the old RTV Silicone Sealant adhering to the gasket application surface and the mating surface.
^ Remove the old RTV Silicone Sealant completely from the groove of the gasket application surface, mounting bolts, and bolt holes.
2. Clean the mating surface to remove dirt, moisture, grease, and foreign material.
3. Attach the RTV Silicone Sealant to the tube presser. Use Genuine RTV Silicone Sealant or equivalent.
4. Apply the RTV Silicone Sealant without breaks to the specified location with the specified dimensions.
^ If there is a groove for the RTV Silicone Sealant application, apply the Sealant to the groove.
^ As for the bolt holes, normally apply the RTV Silicone Sealant inside the holes. Occasionally, it should be applied outside the holes.
^ Within five minutes of gasket application, install the mating component.
^ If the RTV Silicone Sealant protrudes, wipe it off immediately.
^ Do not retighten after the installation.
^ After 30 minutes or more have passed after installation, fill the engine with oil and coolant.
CAUTION: If there are specific instructions in a procedure, observe them.