Headlamp: Adjustments

HEADLAMP (FOR USA)

Aiming Adjustment:

For details, refer to the regulations in your state.
Before performing aiming adjustment, check the following.
1. Ensure all tires are inflated to correct pressure.
2. Place vehicle on flat surface.
3. Ensure there is no load in vehicle other than the driver (or equivalent weight placed in driver's position). Coolant and engine oil filled to correct level, and fuel tank full.


LOW BEAM AND HIGH BEAM
1. Turn headlamp low beam on.
2. Use adjusting screws to perform aiming adjustment.
First loosen the adjusting screw all the way and then make adjustment by tightening the screw.






If the vehicle front body has been repaired and/or the headlamp assembly has been replaced, check aiming. Use the aiming chart shown in the figure.

Basic illuminating area for adjustment should be within the range shown on the aiming chart. Adjust headlamps accordingly.