Operation CHARM: Car repair manuals for everyone.

With Manufacturer's Scan Tool

Consult-II Inspection Procedure
1. Turn ignition switch OFF.




2. Connect "CONSULT-II" and "CONSULT-II CONVERTER" to data link connector, which is located under LH dash panel.
3. Turn ignition switch ON.




4. Touch "START" (NISSAN BASED VHCL).




5. Touch "ENGINE".
If "ENGINE" is not indicated, Diagnostic Aids "CONSULT-II Data Link Connector (DLC) Circuit".




6. Perform each diagnostic test mode according to each service procedure.

For further information, see the CONSULT-II Operation Manual.