Operation CHARM: Car repair manuals for everyone.

P1229

DTC P1229 SENSOR POWER SUPPLY

On Board Diagnosis Logic:






Fail-Safe Mode:






DTC Confirmation Procedure

NOTE: If "DTC Confirmation Procedure" has been previously conducted, always turn ignition switch "OFF" and wait at least 10 seconds before conducting the next test.

TESTING CONDITION: Before performing the following procedure, confirm that battery voltage is more than 10 V at idle.

WITH CONSULT-II
1. Turn ignition switch "ON".




2. Select "DATA MONITOR" mode with CONSULT-II.
3. Start engine and let it idle for 1 second.
4. If DTC is detected, go to "Diagnostic Procedure" below.

WITH GST
Follow the procedure "WITH CONSULT-II" above.

EC-SEN/PW-01:







Wiring Diagram

Diagnostic Procedure

Diagnostic Procedure Step 1 - 2:




Diagnostic Procedure Step 3 - 7: