Removal And Installation

REMOVAL AND INSTALLATION

REMOVAL
1. Remove the front door finisher.
2. Remove the front door window and front door module assembly.




3. Disconnect the interior handle cable and locking knob cable from the back side of the front door finisher.
4. Reach to separate the key cylinder rod and exterior handle rod connection (on the handle).




5. Remove the mounting screws (TORX T30), remove the door lock assembly.
6. Disconnect the door lock actuator connector.




7. Remove the exterior handle mounting bolts, move the exterior handle assembly backward, and then remove it from the panel in front of the exterior handle escutcheon.

Install in the reverse order of removal.

CAUTION: To install each rod, be sure to rotate the rod holder until a click is felt.