Sunroof / Moonroof: Adjustments

Fitting Adjustment

GAP ADJUSTMENT (A-A, C-C)
1. Open sunshade assembly.
2. Tilt glass lid up then remove side trim.
3. Loosen glass lid securing bolts, then tilt glass lid down.
4. Manually adjust glass lid from outside of vehicle so gap is within specifications, and snug securing bolts.
5. Tilt glass lid up and down several times using sunroof switch to ensure smooth operation.
6. Tilt glass lid up and tighten bolts.

NOTE: First tighten left front bolt, then tighten right rear bolt on glass lid to prevent lid from moving while tightening other bolts.

Glass lid assembly mounting bolts : 3.0 - 5.0 N.m (0.3 - 0.5 kg-m, 26 - 43 in-lb)

GAP ADJUSTMENT (B-B)
1. Remove headlining.
2. Loosen sunroof assembly front end, side rail, and front and rear bracket attaching bolts.
3. Carefully slide sunroof assembly side to side until gap is within specifications, and snug securing bolts.
4. Tilt glass lid up and down several times using sunroof switch to ensure smooth operation.
5. Tighten sunroof assembly front end, side rail, and front and rear bracket attaching bolts.

Sunroof assembly mounting bolts

Sunroof assembly front end bolts: 5.1 - 6.5 N.m (0.52 - 0.66 kg-m, 46 - 57 in-lb)

Sunroof assembly side rail bolts: 5.1 - 6.5 N.m (0.52 - 0.66 kg-m, 46 - 57 in-lb)

Sunroof assembly front bracket bolts: 5.1 - 6.5 N.m (0.52 - 0.66 kg-m, 46 - 57 in-lb)

Sunroof assembly rear bracket bolts: 5.1 - 6.5 N.m (0.52 - 0.66 kg-m, 46 - 57 in-lb)




HEIGHT DIFFERENCE ADJUSTMENT
1. Tilt glass lid up and down.
2. Check height difference between roof panel and glass lid, and compare to "A-A" as shown.
3. If necessary, adjust height difference by using the following procedure.
- Loosen glass lid securing bolts.
- Manually raise/lower glass lid until height difference is within specification.
- Tighten glass lid securing bolts.
Glass lid assembly mounting bolts : 3.0 - 5.0 N.m (0.3 - 0.5 kg-m, 26 - 43 in-lb)