Center Mounted Brake Lamp: Service and Repair
Removal and Installation for High-mounted Stop LampWITH REAR SPOILER
When this vehicle is equipped with a rear spoiler, the high-mounted stop lamp uses an LED circuit board instead of a bulb. The LED circuit board is not serviceable, and must be replaced as an assembly.
1. From trunk, disconnect electrical connector.
2. Remove screws, and high-mounted stop lamp assembly.
Installation is the reverse order of removal.
WITHOUT SPOILER
1. Slide high-mounted stop lamp assembly rearward on parcel shelf to give clearance to front tabs.
2. Lift front of lamp assembly up and bring forward to give clearance to rear tabs.
3. Disconnect connector, and remove from vehicle.
Installation is the reverse order of removal.