Replacing Fluid

Replacement
DRAINING
1. Start the engine and let it run to warm up the transaxle.
2. Stop the engine. Remove drain plug and drain oil.
3. Set a gasket on the drain plug and install it on the transaxle.
Drain plug : 30 - 39 Nm (3.1 - 4.0 kg-m, 23 - 28 ft. lbs.)

CAUTION: Do not reuse gasket.

FILLING
1. Remove filler plug. Fill with new oil until oil level reaches the specified limit near filler plug mounting hole.
Oil grade : API GL-4
Capacity (reference): Approximately 2.3 L (4 7/8 US pt. 4 Imp. pt.)
2. After refilling oil, check oil level. Assemble gasket on to filler plug, then install it on the transaxle body.
Filler plug : 30 - 39 Nm (3.1 - 4.0 kg-m, 23 - 28 ft. lbs.)

CAUTION: Do not reuse gasket.