Front

Removal and Installation





^ Remove stabilizer bar, using power tool.
- Prevent the stabilizer connecting rod from turning by inserting a hex wrench into the end of the ball stud, then remove nut.





^ When installing stabilizer, make sure that the clamps are facing in the correct direction as shown.





^ Make sure that slit in bushing is in the position as shown.





^ Install stabilizer bar with ball joint socket properly placed.

Inspection





^ Check stabilizer for deformation or cracks and replace if necessary.
^ Check rubber bushings for deterioration or cracks. Replace if necessary.
^ Check ball joint can rotate in all directions. If movement is not smooth and free, replace stabilizer bar connecting rod.