Windows: Description and Operation

POWER WINDOW SYSTEM

System Description
Power is supplied at all times
- through BCM terminal 28
- to main power window and door lock/unlock switch terminal 5(16).

With ignition switch in ON or START position, power is supplied
- through BCM terminal 29
- to main power window and door lock/unlock switch terminal 12 (17),
- to front power window switch RH terminal 5(13),
- to rear power window switch LH and RH terminal 5.

( ): with left and right front power window anti-pinch system.

AUTO OPERATION
The power window AUTO feature enables the driver (driver and passenger) to open or close the window without holding the window switch in the down or up position.

( ): with left and right front power window anti-pinch system.

POWER WINDOW LOCK
The power window lock is designed to lock operation of all windows except for driver's window.

When the lock switch is pressed to pressed to lock position, ground of the sub-switches in the power window main switch is disconnected. This prevents the power window motors from operating.

DELAYED POWER OPERATION
When the ignition switch is turned to the OFF position, the power window will still operate for up to approximately 45 seconds unless the driver side or passenger side door is opened.

ANTI-PINCH DETECTION FUNCTION
During raising operation of driver or passenger power window (if equipped), if door control module detects that foreign object is pinched, power window lowers approximately 150 mm (5.91 in).

NOTE: Depending on environment and driving conditions, if a similar impact or load is applied to power window, it may lower.

Operation conditions
- Driver and passenger door window is between fully-open and just before fully-closed position (when the limit switch is ON).
- During automatic operation when ignition switch is turned ON.
- During automatic or manual operation when ignition switch is other than ON position (when the timer operates).