Seals and Gaskets: Service and Repair

Replacing Oil Seal
DIFFERENTIAL OIL SEAL





1. Drain gear oil from transaxle.
2. Remove driveshaft.
3. Remove differential oil seals.

CAUTION: Be careful not to damage the case surface when removing the oil seal.





4. Using a drift (special service tool), drive the oil seal straight until it protrudes from the case end equal to dimension A shown in the figure.
Dimension "A": Within 0.5 mm (0.020 inch) of flush with the case.
Drift to be used: ST30720000 (325405)

CAUTION:
^ When installing oil seals, apply multipurpose grease to oil seal lips.
^ Oil seals are not reusable. Never reuse them.

5. Install all parts in reverse order of removal and check oil level after installation.