Input Shaft End Play

Input Shaft End Play





^ When adjusting input shaft end play, select adjusting shim for input shaft bearing. To select adjusting shim, measure clearance between transaxle case and input shaft rear bearing.
^ Calculate dimension "O" (thickness of adjusting shim) using the following procedure to satisfy specification of end play for input shaft rear bearing.
End play: 0 - 0.06 mm (0 - 0.0024 inch)
Dimension "O" = (O' - O2 ) + End play
O: Thickness of adjusting shim
O1: Distance between transaxle case end face and mounting face of adjusting shim
O2: Distance between clutch housing case end face and end face of input shaft rear bearing





Adjusting Shim

CAUTION: Only 1 adjusting shim can be selected.





1. Using depth micrometer and straight edge, measure dimension "Or" between transaxle case end face and mounting face of adjusting shim.





2. Using depth micrometer and straight edge as shown in the figure, measure dimension "O2" between clutch housing case end face and end face of input shaft rear bearing.
3. Install selected input shaft rear bearing adjusting shim onto input shaft.