Road Test
DESCRIPTION
The purpose of the test is to determine overall performance of A/T and analyze causes of problems.
The road test consists of the following three parts:
1. Check before engine is started
2. Check at idle
3. Cruise test
^ Before road test, familiarize yourself with all test procedures and items to check.
^ Conduct tests on all items until specified symptom is found. Troubleshoot items which check out No Good after road test. Refer to Transmission Control Systems.
1 Of 2:
2 Of 2:
1. CHECK BEFORE ENGINE IS STARTED
1 Of 7:
2 Of 7:
3 Of 7:
4 Of 7:
5 Of 7:
6 Of 7:
2. CHECK AT IDLE
3. CRUISE TEST
^ Check all items listed in Parts 1 through 3.
With CONSULT-II
^ Using CONSULT-II, conduct a cruise test and record the result.
^ Print the result and ensure that shifts and lock-ups take place as per Shift Schedule.
CONSULT-II Setting Procedure
1. Turn ignition switch OFF.
2. Connect CONSULT-II to data link connector, which is located in left side dash panel.
3. Turn ignition switch ON.
4. Touch "START
5. Touch "A/T".
6. Touch "DATA MONITOR".
7. Touch "MAIN SIGNALS" or "TOM INPUT SIGNALS".
8. See "Numerical Display", "Bar chart Display" or "Line Graph Display".
9. Touch "SETTING" to set recording condition ("AUTO TRIG" or "MANU TRIG") and touch "BACK".
10. Touch "Start".
11. When performing cruise test, touch "RECORD".
12. After finishing cruise test part 1, touch "STOP".
13. Touch "STORE" and touch "BACK".
14. Touch "DISPLAY".
15. Touch "PRINT".
16. Check the monitor data printed out.
17. Continue cruise test part 2 and 3.
Without CONSULT-II
^ Accelerator pedal position sensor (throttle position sensor) can be checked by voltage between terminals 41 (W) and 42 (B) of TCM.
1 Of 8:
2 Of 8:
3 Of 8:
4 Of 8:
5 Of 8:
6 Of 8:
7 Of 8:
8 Of 8:
Cruise Test-Part 1
1 Of 4:
2 Of 4:
3 Of 4:
4 Of 4:
Cruise Test-Part 2
1 Of 6:
2 Of 6:
3 Of 6:
4 Of 6:
5 Of 6:
6 Of 6:
Cruise Test-Part 3