Replacing Fluid
ReplacementDRAINING
1. Start the engine and let it run to warm up the transaxle.
2. Stop the engine. Remove drain plug and drain oil.
3. Set a gasket on the drain plug and install it on the transaxle.
Drain plug : 10 - 19 Nm (1.0 - 2.0 kgf-cm, 87 - 173 inch lbs.)
CAUTION: Do not reuse gasket.
FILLING
1. Remove filler plug. Fill with new oil until oil level reaches the specified limit near filler plug mounting hole.
Oil grade : API GL-4
Capacity (reference) : Approximately 3.0 L (31/8 qt)
2. After refilling oil, check oil level. Set a new gasket on the filler plug, then install it in the transaxle body.
Filler plug : 10 - 19 Nm (1.0 - 2.0 kgf-cm, 87 - 173 inch lbs.)
CAUTION: Do not reuse gasket.