Engine Cannot Be Started In "P" and "N" Position

2. Engine Cannot Be Started In "P" and "N" position

SYMPTOM:
^ Engine cannot be started with selector lever in "P" or "N" position.
^ Engine can be started with selector lever in "D", "2", "1" or "R" position.

1. CHECK PNP SWITCH CIRCUIT
With CONSULT-II
Does "TCM INPUT SIGNALS" in "DATA MONITOR" show damage to PNP switch circuit?





Without CONSULT-II
Does self-diagnosis show damage to PNP switch circuit?
Yes or No
Yes >> Check PNP switch circuit. Refer to "DTC P0705 PARK/NEUTRAL POSITION (PNP) SWITCH".
No >> GO TO 2.

2. CHECK PNP SWITCH INSPECTION





Check for short or open of PNP switch harness connector terminals 1 and 2. Refer to "Diagnostic Procedure".
OK or NG,
OK >> GO TO 3.
NG >> Repair or replace PNP switch.

3. CHECK STARTING SYSTEM
Check starting system.
OK or NG
OK >> INSPECTION END
NG >> Repair or replace damaged parts.