With Manufacturer's Scan Tool

CONSULT-II

CONSULT-II Inspection Procedure
SELF-DIAGNOSIS PROCEDURE
1. Turn ignition switch OFF.





2. Connect CONSULT-II to Data Link Connector.
3. Start engine.
4. Drive vehicle over 30 km/h (19 MPH) for at least one minute.





5. Stop vehicle with engine running and touch "START" on CONSULT-II screen.





6. Touch "ABS".





7. Touch "SELF-DIAG RESULTS".
- The screen shows the detected malfunction and how many times the ignition switch has been turned ON since the malfunction.

8. Make the necessary repairs following the diagnostic procedures.





9. After the malfunctions are repaired, erase the self-diagnostic results stored in the control unit by touching "ERASE".
10. Check warning lamp for deactivation after driving vehicle over 30 km/h (19 MPH) for at least one minute.
11. Test the ABS in a safe area to verify that it functions properly.

SELF-DIAGNOSTIC RESULTS MODE





1 of 2





2 of 2