Disassembly and Assembly
PREPARATION
1. Attach the spacer to the tip of the radiator plate pliers A.
Spacer specification:.......................1.5 mm (0.059 inch) thick x 18 mm (0.71 inch) wide x 8.5 mm (0.335 inch) long.
2. Make sure that when radiator plate pliers A are closed dimension H" is approximately 7.6 mm (0.299 inch).
3. Adjust dimension H".with the spacer, if necessary.
DISASSEMBLY
1. Remove tank with Tool.
Grip the crimped edge and bend it upwards so that the Tool slips off.
CAUTION: Do not bend excessively.
In areas where Tool cannot be used, use a screwdriver to bend the edge up.
CAUTION: Be careful not to damage tank.
2. Make sure the edge stands straight up.
3. Remove oil cooler from tank (A/T model only).
ASSEMBLY
1. Install oil cooler (A/T model only).
Pay attention to direction of conical washer.
2. Clean contact portion of tank.
3. Install sealing rubber.
Push it in with fingers.
Be careful not to twist sealing rubber.
4. Crimp tank in specified sequence with Tool.
Use pliers in the locations where Tool cannot be used.
5. Make sure that the rim is completely crimped down.
Standard height "H"........................8.0 - 8.4 mm (0.315 - 0.331 inch)
6. Confirm that there is no leakage.
INSPECTION
1. Apply pressure with Tool.
Specified pressure value:.......................157 kPa (1.6 kg/cm2, 23 psi)
WARNING: To prevent the risk of the hose coming undone while under pressure, securely fasten it down with a hose clamp. Attach a hose to the oil cooler as well (A/T model only).
2. Check for leaks in dip tank.