Removal And Installation

DOOR LOCK

Removal and Installation

REMOVAL
1. Remove the door finisher.
2. Remove the door window and door module assembly.




3. Disconnect the inside handle cable and locking knob cable from the back side of the door finisher.
4. Reach to separate the key cylinder (driver side only) rod and outside handle rod connection (on the handle).
5. Disconnect the door lock actuator connector.




6. Remove the mounting screws (TORX T30), remove the door lock assembly.




7. Remove the outside handle mounting bolts, remove the outside handle.

INSTALLATION
Install in the reverse order of removal.

CAUTION:
- To install each rod, be sure to rotate the rod holder until a click is felt.
- After installing, check operation.
- After installing, perform fitting adjustment. Refer to "Fitting Adjustment".