Seats: Service and Repair

MANUAL SEAT

Manual Seat (Coupe) Part 1:

Manual Seat (Coupe) Part 2:

POWER SEAT

Power Seat Part 1:

Power Seat Part 2:

Net Seat (Roadster) Part 1:

Net Seat (Roadster) Part 2:

NET SEAT

REMOVAL
When removing or installing the seat trim, carefully handle it to keep dirt out and avoid damage.

CAUTION:
- Before removing the seat, turn the ignition switch off, disconnect both battery cables and wait at least 3 minutes.
- When checking the power seat circuit for continuity using a circuit tester, do not confuse its connector with the side air bag module connector. Such an error may cause the air bag to deploy.
- Do not drop, tilt, or bump the side air bag module installing in the seat. Always handle it with care.

1. Remove the front leg cover and rear leg cover.(LH/RH)
2. Slide the seat until the body mounting bolts are visible and a tool can be inserted.
3. Disconnect both battery cables.




4. Remove mounting bolts from vehicle, and disconnect harness connector from under seat cushion.
5. Remove fastening clips under seat cushion, and remove seats from vehicle.

INSTALLATION
Install in the reverse order of removal.