13. Brake Fluid Level Sensor System
INSPECTION PROCEDURE1. SELF-DIAGNOSIS RESULT CHECK
1. Check the brake reservoir tank fluid level. If the level is low, add brake fluid.
2. Erase the self-diagnosis results and check the self-diagnosis results.
Self-diagnosis results
Brake fluid level switch
Is the above displayed in the self-diagnosis display items?
YES >> GO TO 2.
NO >> Inspection End
2. CONNECTOR INSPECTION
1. Disconnect the brake fluid level sensor connector E44 and VDC/TCS/ABS control unit connector and check the terminal for deformation, disconnection, looseness, and so on. If there is any non-standard condition, repair or replace the terminal.
2. Securely reconnect the connectors and Re-conduct self-diagnosis.
OK or NG
OK >> The connector terminal contact is loose, damaged, open or shorted.
NG >> GO TO 3.
3. CHECK THE HARNESS BETWEEN THE BRAKE FLUID LEVEL SENSOR AND THE VDC/TCS/ABS CONTROL UNIT
1. Turn off the ignition switch and disconnect the brake fluid level sensor connector E44, VDC/TCS/ABS control unit, connectors E118.
2. Check the continuity between the brake fluid level sensor connector E44 and the VDC/TCS/ABS control unit connector.
OK or NG
OK >> Connect the connectors and conduct a VDC/TCS/ABS control unit self-diagnosis.
NG >> If the open or short in harness, repair or replace the harness.