Without Transmitter Activation Tool

ID REGISTRATION WITHOUT TRANSMITTER ACTIVATION TOOL
1. Turn ignition switch "OFF".
2. Connect CONSULT-II and CONSULT-II CONVERTER to data link connector.

NOTE: If "AIR PRESSURE MONITOR" is not indicated, go to "CONSULT-II Data Link Connector (DLC) Circuit".
3. Touch "AIR PRESSURE MONITOR", "WORK SUPPORT" and "ID REGIST".
4. Adjust the tire pressure to the values shown in the table for ID registration, and drive the vehicle at 15 km/h (9.4 MPH) or more for a few minutes.





5. When ID registration of each wheel has been completed, a buzzer sounds and hazard warning lamp blinks.





6. After completing all ID registrations, press "END" to complete the procedure.