Removal and Installation

USA/CANADA

REMOVAL
1. Open the driver and front passenger window, and then disconnect the battery negative cable.

CAUTION: After the battery cables are disconnected, do not open/close the driver and/or front passenger door with the window in the full up position. The automatic window adjusting function will not work and the side roof panel may be damaged.




2. Remove front bumper.
3. Remove headlamp mounting bolts.
4. Pull head lamp toward vehicle front, disconnect connector, and remove headlamp.

INSTALLATION
Installation in the reverse order if removal. Be careful of the following.

Headlamp mounting bolt:
Torque: 6.1 N.m (0.62 kg-m, 54 in-lb)

NOTE: After installation, aiming adjustment. Refer to "Aiming Adjustment".

Servicing to Replace Headlamps When Damaged




If only installation part as shown in the figure is damaged, and headlamp housing itself is not damaged, repair can be completed easily by installing correction brackets.

INSTALLATION OF HEADLAMP BRACKET




1. Remove headlamps.
2. Cut damaged section of installation part, then shape with sandpaper.
3. Attach each correction bracket to headlamp housing boss with 2 screws.

RH headlamp Inner side 26040 CD000
LH headlamp Inner side 26090 CD000