With Manufacturer's Scan Tool
SELF-DIAGNOSTIC PROCEDURE (WITH CONSULT-II)
CONSULT-II setting procedure
CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carry out CAN communication.
^ For details, refer to the separate "CONSULT-II Operations Manual".
1. Turn ignition switch "OFF".
2. Connect CONSULT-II and CONSULT-II CONVERTER to data link connector, which is located in instrument lower panel on driver side.
3. Turn ignition switch "ON". (Do not start engine.)
4. Touch "START (NISSAN BASED VHCL) ".
5. Touch"A/T".
If "A/T" is not indicated, go to "CONSULT-II Data Link Connector (DLC) Circuit". Refer to "CONSULT-II Checking System". Diagnostic Aids
6. Perform each diagnostic test mode according to each service procedure.
Self-diagnostic result test mode
Data monitor mode (A/T)
DTC WORK SUPPORT MODE WITH CONSULT-II
CONSULT-II setting procedure
CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which may carry out CAN communication.
^ For details, refer to the separate "CONSULT-II Operation Manual".
1. Turn ignition switch "OFF".
2. Connect CONSULT-II and CONSULT-II CONVERTER to data link connector, which is located in instrument lower panel on driver side.
3. Turn ignition switch "ON".(Do not start engine.)
4. Touch "START (NISSAN BASED VHCL)".
5. Touch"A/T".
If "A/T" is not indicated, go to "CONSULT-II Data Link Connector (DLC) Circuit". Refer to "CONSULT-II Checking System". Diagnostic Aids
6. Touch "DTC WORK SUPPORT".
7. Touch select item menu.
8. Touch "START".
9. Perform driving test according to "DTC CONFIRMATION PROCEDURE" in "TROUBLE DIAGNOSIS FOR DTC".
^ When testing conditions are satisfied, CONSULT-II screen changes from "OUT OF CONDITION" to "TESTING".
10. Stop vehicle. If "NO" appears on the screen, malfunction may exist. Go to "DIAGNOSTIC PROCEDURE".
11. Perform test drive to check gear shift feeling in accordance with instructions displayed.
12. Touch "YES" or "NO".
13. CONSULT-II procedure is ended.
If "NO" appears on the screen, a malfunction may exist. Go to "DIAGNOSTIC PROCEDURE".
DTC WORK SUPPORT MODE