Vehicle Does Not Creep Forward In "D" Position

Vehicle Does Not Creep Forward In "D" Position

SYMPTOM: Vehicle does not creep forward when selecting "D" position.

DIAGNOSTIC PROCEDURE
1. CHECK A/T FLUID LEVEL
Check the A/T fluid level.
OK or NG
OK >>GO TO 2.
NG >>Refill ATF.

2. CHECK SELF-DIAGNOSIS RESULTS
Perform self-diagnosis. Refer to "SELF-DIAGNOSTIC PROCEDURE (WITH CONSULT-II)", "TCM SELF-DIAGNOSTIC PROCEDURE (NO TOOLS)".
Do the self-diagnosis results indicate accelerator pedal position sensor, CAN communication line, PNP switch?
YES >>Check the malfunctioning system. Refer to "DTC U1000 CAN COMMUNICATION LINE", "DTC P0705 PARK/NEUTRAL POSITION SWITCH".

For "DTC P2122. P2123 APP SENSOR", "DTC P2127. P2128 APP SENSOR", "DTC P2138 APP SENSOR", DTC No. Index

NO >>GO TO 3.

3. CHECK LINE PRESSURE
Check the line pressure at idle with selector lever in "R" position. Refer to "LINE PRESSURE TEST".
OK or NG
OK >>GO TO 4.
NG >>Check the line pressure solenoid valve. Refer to "DTC P0745 LINE PRESSURE SOLENOID VALVE".

4. CHECK CONTROL LINKAGE
Check the control linkage.
^ Refer to "Checking of A/T Position".
OK or NG
OK >>GO TO 5.
NG >>Adjust control linkage. Refer to "Adjustment of A/T Position" .

5. CHECK SYMPTOM
Check again.
OK or NG
OK >>INSPECTION END
NG >>GO TO 6.

6. CHECK TCM
Perform TCM input/output signal inspection. Refer to "TCM Input/Output Signal Reference Values".
OK or NG
OK >>INSPECTION END
NG >>GO TO 7.

7. DETECT MALFUNCTIONING ITEM
Check the following items:
^ Power supply and ground circuit for TCM.
^ A/T assembly harness connector pin terminals for damage or loose connection with harness connector.
OK or NG
OK >>Replace the transmission assembly.
NG >>Repair or replace damaged parts.