Diagnostic Procedure 2
DIAGNOSTIC PROCEDURE 2CAUTION:
If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carry out CAN communication.
1. Turn ignition switch OFF.
2. Connect CONSULT-II and CONSULT-II CONVERTER to the data link connector.
3. Turn ignition switch ON.
4. Touch "START (NISSAN BASED VHCL)".
5. Touch "AIR BAG".
If "AIR BAG" is not indicated, go to "CONSULT-II Data Link Connector (DLC) Circuit".
6. Touch "SELF-DIAG [CURRENT]".
7. Diagnostic code is displayed on "SELF-DIAG [CURRENT]".
If no malfunction is detected on "SELF-DIAG [CURRENT]" even though malfunction is detected in "SRS Operation Check", check the battery voltage. If the battery voltage is less than 9 V, charge or replace the battery. "DIAGNOSTIC PROCEDURE 3". If the battery voltage is OK, go to "DIAGNOSTIC PROCEDURE 4 (CONTINUED FROM DIAGNOSTIC PROCEDURE 2)" diagnose the following cases:
- Self-diagnostic result "SELF-DIAG [PAST]" (previously stored in the memory) might not be erased after repair.
- The SRS system malfunctions intermittently.
CONSULT-II Diagnostic Code Chart (SELF-DIAG [CURRENT]) Part 1:
CONSULT-II Diagnostic Code Chart (SELF-DIAG [CURRENT]) Part 2:
CONSULT-II Diagnostic Code Chart (SELF-DIAG [CURRENT]) Part 3:
CONSULT-II Diagnostic Code Chart ("SELF-DIAG [CURRENT]")
NOTE:
- Follow the procedures in numerical order when repairing malfunctioning parts. Confirm whether malfunction is eliminated using air bag warning lamp or CONSULT-II each time repair is finished. If malfunction is still observed, proceed to the next step. When malfunction is eliminated, further repair work is not required.