Removal And Installation

Removal And Installation:

REMOVAL
1. Open the driver and front passenger window, and then disconnect the battery negative cable.

CAUTION: After the battery cables are disconnected, do not open/close the driver and/or front passenger door with the window in the full up position. The automatic window adjusting function will not work and the side roof panel may be damaged.




2. Remove engine under cover, using power tools.
3. Disconnect S connector.
4. Remove B terminal nut.
5. Remove starter motor mounting bolts and harness connector clip bracket, using power tools.
6. Remove starter motor to the direction of under side the vehicle.

INSTALLATION
Install in the reverse order of removal.

CAUTION:
Be sure to tighten B terminal nut carefully.