Cruise Test - Part 2

Cruise Test - Part 2
Cruise test Part 2
1. CHECK STARTING FROM D1
1. Move selector lever the "D" position.
2. Accelerate at half throttle.
With CONSULT-II
Read the gear position. Refer to "Data monitor mode (A/T)".
Does it start from D1?
YES >>GO TO 2.
NO >>Enter a check mark at "Vehicle Cannot Be Started From D1" on the diagnostics worksheet, then continue the road test.

2.CHECK SHIFT UP D1 -> D2
Press the accelerator pedal down all the way and inspect whether or not the transmission shifts up (D1 -> D2) at the correct speed.

With CONSULT-II
Read the gear position, throttle position and vehicle speed. Refer to "Data monitor mode (A/T)".
Does the A/T shift up D1 -> D2 at the correct speed?
YES >>GO TO 3.
NO >>Enter a check mark at "Vehicle Does Not Shift D1 -> D2" on the diagnostics worksheet, then continue the road test.

3. CHECK SHIFT UP D2 -> D3
Press the accelerator pedal down all the way and inspect whether or not the transmission shifts up (D2 -> D3) at the correct speed.

With CONSULT-II
Read the gear position, throttle position and vehicle speed. Refer to "Data monitor mode (A/T)".
Does the A/T shift up D2 -> D3 at the correct speed?
YES >>GO TO 4.
NO >>Enter a check mark at "Vehicle Does Not Shift D2 -> D3" on the diagnostics worksheet, then continue the road test.

4. CHECK SHIFT UP D3 -> D4 AND ENGINE BRAKE
When the transmission changes speed D3 -> D4, return the accelerator pedal.

With CONSULT-II
Read the gear position. Refer to "Data monitor mode (A/T)".
Does the A/T shift up D3 -> D4 and apply the engine brake?
YES >>
1. Stop the vehicle.
2. See Cruise Test - Part 2
NO >>Enter a check mark at "Vehicle Does Not Shift D3 -> D4" on the diagnostics worksheet, then continue the road test.