Removal and Installation

Removal and Installation

REMOVAL
1. Remove rear propeller shaft from the final drive.

CAUTION: Do not impact or damage propeller shaft tube.

2. Remove rear stabilizer bar with power tool.





3. Remove drive shaft from final drive. Then suspend it by wire etc.
4. Remove breather hose from the final drive.
5. Remove ABS wheel sensor.
6. Place a transmission jack on the final drive.

CAUTION: Do not place a transmission jack on the rear cover (aluminum case).

7. Remove the mounting bolts and nuts connecting to the suspension member, and remove the rear final drive.

INSTALLATION
Install in the reverse order of removal.

CAUTION: After installation, check the final drive oil level.