With Manufacturer's Scan Tool

CONSULT-II Inspection Procedure

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunction might be detected in self-diagnosis depending on control unit which carry out CAN communication.




1. Turn ignition switch "OFF".
2. Connect "CONSULT-II" and CONSULT-II CONVERTER to the data link connector.




3. Turn ignition switch "ON".
4. Touch "START (NISSAN BASED VHCL)".




5. Touch "BCM".
If "BCM" is not indicated, go to GI-39 , "CONSULT-II Data Link Connector (DLC) Circuit" Data Link Connector Schematic




6. Touch "RETAINED PWR".




7. Select diagnosis mode.
"DATE MONITOR","ACTIVE TEST" and "WORK SUPPORT" are available.