Rear Wiper Arms

Removal and Installation for Rear Wiper Arm, Adjustment for Wiper Arms Stop Location




1. Prior to wiper arm installation, turn on wiper switch to operate wiper motor and then turn it "OFF" (Auto Stop).
2. Lift the blade up and then set it down onto glass surface to set the blade center to clearance "L" immediately before tightening nut.
3. Eject washer fluid. Turn on wiper switch to operate wiper motor and then turn it "OFF".
4. Ensure that wiper blades stop within clearance "L".
Clearance "L" : 22.5 - 37.5 mm (0.886 - 1.476 in)

- Tighten wiper arm nuts to specified torque.
Rear wiper : 12.7 - 17.6 Nm (1.3 - 1.7 kg-m, 10 - 12 ft-lb)