Rear Wiper Motor

Removal and Installation of Rear Wiper Motor




REMOVAL
1. Operate wiper motor, and stop it at the auto stop position.
2. Remove cover wiper arm.
3. Remove wiper arm nut, and remove wiper arm from vehicle.
4. Remove pivot cap.
5. Remove back door finisher lower. Refer to "BACK DOOR" in Exterior and Interior.
6. Remove wiper motor connector.
7. Disconnect rear wiper motor mounting screws and remove rear wiper motor.




INSTALLATION
1. Clean up the pivot area as illustrated. This will reduce possibility of wiper arm looseness.
2. Attach pivot cap.
3. Install rear wiper motor to the vehicle.
4. Connect rear wiper motor to the connector. Turn rear wiper switch ON to operate rear wiper motor, then turn wiper switch OFF (auto stop).
5. Install back door finisher lower. Refer to "BACK DOOR" in Exterior and Interior.
6. Attach wiper arm.
Rear wiper motor mounting screw : 5.5 Nm (0.56 kg-m, 49 in-lb)

CAUTION: Do not drop the wiper motor or cause it to contact other parts.