TCS/ABS

ACTUATOR AND ELECTRIC UNIT (ASSEMBLY)





Removal and Installation

REMOVAL
1. Disconnect battery cable.
2. Remove windshield wiper and linkage assembly.
3. Drain brake fluid.
4. Discharge the A/C refrigerant.
5. Disconnect and remove high-pressure and low-pressure A/C pipes to allow access to ABS actuator and electric unit (control unit).
6. Disconnect harness connectors from ABS actuator and electric unit (control unit).
7. Disconnect brake pipes.
8. Remove fasteners for ABS actuator and electric unit (control unit) and remove from vehicle.

INSTALLATION

CAUTION: After installation of ABS actuator and electric unit (control unit), refill brake fluid. Then bleed air from system.

1. Position ABS actuator and electric unit (control unit) in vehicle.
2. Connect brake pipes and fasteners temporarily.
3. Tighten fasteners and brake pipes.
4. Connect ABS actuator and electric unit (control unit) harness connectors.
5. Install and connect high-pressure and low-pressure A/C pipes.
6. Install windshield wiper and linkage assembly.
7. Reconnect battery cable.
8. Evacuate and recharge the A/C system.