Trunk Lid

TRUNK LID




Fitting Adjustment

LONGITUDINAL AND LATERAL CLEARANCE ADJUSTMENT
1. Remove trunk rear finisher. Refer to "TRUNK ROOM TRIM & TRUNK LID FINISHER".
2. Loosen trunk lid hinge mounting bolts, and remove trunk lid lock. And then, close trunk lid.
3. Tighten trunk lid hinge mounting bolts to the specified torque after adjusting lateral clearance and clearance to storage lid and rear bumper fascia.
4. Position trunk lid lock and engage trunk lid striker. Check trunk lid striker and trunk lid lock for looseness.
5. Tighten trunk lid mounting bolts to the specified torque.

SURFACE HEIGHT ADJUSTMENT
1. Remove trunk rear finisher. Refer to "TRUNK ROOM TRIM & TRUNK LID FINISHER".
2. Remove trunk lid lock. Rotate bumper rubber to adjust height between trunk lid and bumper fascia.
3. Position trunk lid lock and engage trunk lid striker. Check trunk lid striker and trunk lid lock for looseness.
Tighten trunk lid mounting bolts to the specified torque.
4. Adjust lateral clearance and surface height between trunk lid and other parts so that they are within the following dimensional difference.

CAUTION: Adjust evenness between trunk lid and each part to the following specification.

Trunk lid and storage lid (A-A): 0±1.0 mm (0±0.04 in)
Trunk lid and rear bumper fascia (D-D): 0.85±2.1 mm (0.0335±0.083 in)