Front Lower Link

FRONT LOWER LINK

Part 1:

Part 2:

Removal and Installation

REMOVAL
1. Remove tire with power tool.
2. Set jack under rear lower link.
3. Remove fixing nut and bolt between front lower link and rear suspension member with power tool.
4. Remove fixing nut and bolt between front lower link and axle with power tool.
5. Remove front lower link from vehicle.

INSPECTION AFTER REMOVAL
^ Check front lower link and bushing for any deformation, cracks, or damage. Replace if necessary.

INSTALLATION
^ Refer to "Components" for tightening torque. Install in the reverse order of removal.

NOTE: Refer to component parts location and do not reuse non-reusable parts.

^ Perform final tightening of rear suspension member and axle installation position (rubber bushing) under unladen condition with tires on level ground. Check wheel alignment.