Draining and Filling Fluid

M/T OIL

Replacement

DRAINING
1. Start the engine and warm up the transmission unit sufficiently.
2. After stopping engine, remove filler plug and drain plug and then drain fluid.
3. After replace a new gasket on drain plug, screw drain plug into transmission body and tighten to the specified torque.

CAUTION: Gaskets are not reusable. Never reuse them.

FILLING
1. Remove filler plug. Fill new oil into the transmission to the level of the filler plug mounting hole.
Oil grade: API GL-4
Viscosity: Refer to "Fluids and Lubricants".
Oil capacity: Approximately 2.9 liters (3-1/8 US quarts 2-1/2 Imp quarts)
2. After filling, check fluid level, replace a new gasket on filler plug, screw filler plug into transmission body, and tighten to the specified torque.

CAUTION: Gaskets are not reusable. Never reuse them.