In "N" Position, Vehicle Moves
In "N" Position, Vehicle MovesSYMPTOM:
Vehicle moves forward or backward when selecting "N" position.
DIAGNOSTIC PROCEDURE
1. CHECK PNP SWITCH CIRCUIT
Perform self-diagnosis. Refer to AT-94, "SELF-DIAGNOSTIC RESULT MODE", With Manufacturer's Scan Tool AT-104, "Diagnostic Procedure Without CONSULT-II". Without Scan Tool
Do the self-diagnostic results indicate PNP switch?
YES >> Check the malfunctioning system. Refer to "DTC P0705 PARK/NEUTRAL POSITION SWITCH".
NO >> GO TO 2.
2. CHECK CONTROL LINKAGE
Check control linkage. Refer to "Checking of A/T Position".
OK or NG
OK >> GO TO 3.
NG >> Adjust control linkage.
3. CHECK A/T FLUID LEVEL
Check A/T fluid level. Refer to "Checking A/T Fluid".
OK or NG
OK >> GO TO 4.
NG >> Refill ATF.
4. CHECK A/T FLUID CONDITION
1. Remove oil pan.
2. Check A/T fluid condition. Refer to "Fluid Condition Check".
OK or NG
OK >> GO TO 5.
NG >> Check the malfunction items. If any items are damaged, repair or replace damaged parts. Refer to "symptom Chart" (Symptom No. 67)
5. CHECK SYMPTOM
Check again. Refer to "Check at Idle".
OK or NG
OK >> INSPECTION END
NG >> GO TO 6.
6. CHECK TCM
1. Check TCM input/output signals. Refer to "TCM Input/Output Signal Reference Values".
2. If NG, recheck A/T assembly harness connector terminals for damage or loose connection with harness connector.
OK or NG
OK >> INSPECTION END
NG >> Repair or replace damaged parts.