With Manufacturer's Scan Tool

CONSULT-II INSPECTION PROCEDURE

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunction might be detected in self-diagnosis depending on control unit which carry out CAN communication.

1. Turn ignition switch "OFF".




2. Connect "CONSULT-II" and CONSULT-II CONVERTER to the data link connector.
3. Turn ignition switch "ON".




4. Touch "START (NISSAN BASED VHCL)".




5. Touch "BCM".
If "BCM" is not indicated, go to GI-39, "CONSULT-II Data Link Connector (DLC) Circuit. Data Link Connector Schematic




6. Touch "RETAINED PWR".




7. Select diagnosis mode.
DATE MONITOR, ACTIVE TEST and WORK SUPPORT are available.