Rear Wiper Motor

Removal and Installation of Rear Wiper Motor

REMOVAL
1. Operate rear wiper motor, and stop it at auto stop position.
2. Remove cover wiper arm.
3. Remove wiper arm nut, and remove wiper arm from vehicle.
4. Remove pivot cap.
5. Remove back door finisher lower. Refer to "BACK DOOR FINISHER" in "Exterior & Interior".
6. Remove wiper motor connector.




7. Disconnect rear wiper motor mounting bolts and remove rear wiper motor.

INSTALLATION




1. Clean up the pivot area as illustrated. This will reduce possibility of wiper arm looseness.
2. Attach pivot cap.
3. Install rear wiper motor to the vehicle.
4. Connect rear wiper motor to connector. Turn rear wiper switch ON to operate rear wiper motor, then turn wiper switch OFF (auto stop).
5. Install back door finisher lower. Refer to "BACK DOOR FINISHER" in "Exterior & Interior".
6. Attach wiper arm.

Rear wiper motor mounting screw : 5.5 Nm (0.56 kg-m, 49 in-lb)

CAUTION: Never drop wiper motor or cause it to contact other parts.