ABS/TCS
Controller FailureDIAGNOSTIC PROCEDURE
With CONSULT-II: Malfunction code No. C1110
Without CONSULT-II: Malfunction code No. 71
1. INSPECTION START
ABS actuator and electric unit (control unit) power supply and ground circuit inspection.
>> GO TO 2.
2. CHECK CONNECTOR
1. Disconnect ABS actuator and electric unit (control unit) connector E125. Check terminals for deformation, disconnection, looseness or damage. Then reconnect connector.
2. Repeat self-diagnosis.
Does warning lamp activate again?
YES >> GO TO 3.
NO >> Inspection End.
3. CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) POWER SUPPLY CIRCUIT
Check voltage. Refer to "DIAGNOSTIC PROCEDURE".
Does battery voltage exist when ignition switch is turned ON?
YES >> GO TO 4.
NO >> Repair.
4. SELF-DIAGNOSIS RESULT CHECK
Check the self-diagnosis results.
Malfunction code
71
Diagnostic trouble code
C1110
Are the above items indicated in self-diagnosis results?
YES >> Replace ABS actuator and electric unit (control unit). Refer to "Removal and Installation".
NO >> Inspect the system according to the indicated code No.