Body Side Trim

BODY SIDE TRIM




Removal and Installation

CAUTION:
- Wrap the tip of flat-bladed screwdriver with a cloth when removing metal clips from garnishes.
- When removing or installing body side welts, do not allow butyl seal to come in contact with pillar garnish.

CENTER PILLAR LOWER GARNISH

Removal and Installation
1. Remove front and rear kicking plate.
2. Remove center pillar lower garnish.

Installation is in the reverse order of removal.

CENTER PILLAR UPPER GARNISH

Removal and Installation
1. Remove seat belt shoulder anchor. Refer to "Removal and Installation of Front Seat Belt".
2. Remove center pillar lower garnish. Refer to "CENTER PILLAR LOWER GARNISH" .
3. Remove bolt covers and bolts.
4. Remove center pillar upper garnish.

Installation is in the reverse order of removal.

REAR PILLAR FINISHER

Removal and Installation
1. Remove bolt cover and bolt.
2. Remove rear pillar finisher.

Installation is in the reverse order of removal.

DASH SIDE FINISHER

Removal and Installation
1. Remove front kicking plate.
2. Remove dash side finisher.







CAUTION: Insert screw driver rolled with cloth between panel on vehicle and clips (as indicated with arrow), and disconnect clips.

Installation is in the reverse order of removal.