Removal And Installation

Removal and Installation

REMOVAL
1. Remove the front door finisher. Refer to "DOOR FINISHER".
2. Remove the front door window and front door module assembly. Refer to "FRONT DOOR GLASS AND REGULATOR" .
3. Separate the key cylinder rod and exterior handle rod connection (on the handle) if equipped.




4. Remove the screws (TORX T30) and the door lock assembly.
5. Disconnect the door lock actuator electrical connector.




6. Remove the exterior handle bolts, move the exterior handle assembly backward, and then remove it from the panel in front of the exterior handle escutcheon.

Installation should be performed in the reverse procedure of removal.

CAUTION: To install each rod, be sure to rotate the rod holder until a click is felt.