Front Seat
Driver SeatDriver Seat Part 1:
Driver Seat Part 2:
REMOVAL
When removing or installing the seat trim, handle it carefully to keep dirt out and avoid damage.
CAUTION:
- Before removing the front seat, turn the ignition switch off, disconnect both battery cables and wait and least 3 minutes.
- When checking the power seat circuit for continuity using a circuit tester, do not confuse its connector with the side air bag module connector. Such an error may cause the air bag to deploy.
- Do not drop, tilt, or bump the side air bag module while installing the seat. Always handle it with care.
- After front side air bag module inflates, front seatback assembly must be replaced.
- Some front seats are equipped with an Occupant Classification System sensor and control module. Do not disassemble front passenger seat cushion assembly or remove trim as this will affect the Occupant Classification System calibration.
- Always replace passenger seat cushion as an assembly if equipped with Occupant Classification System.
1. Slide the seat until the four body mounting bolts are visible and a tool can be inserted.
NOTE:
- When disassembling the driver seat after removal, set the front/rear cushion lifter to the top position.
2. Disconnect both battery cables and wait at least 3 minutes.
3. Remove the harness connector for the side air bag module.
4. Remove the four body mounting bolts and the seat belt anchor bolt.
To remove the seat belt anchor bolt, refer to "Removal and Installation of Front Seat Belt" .
5. Remove the power seat harness connector and vehicle harness fixing clip from the vehicle.
NOTE: When removing and installing, use shop cloths to protect the parts from damage where they may interfere with other parts.
INSTALLATION
- Install in the reverse order of removal.
NOTE: Be sure to insert the rear end tab of the rear leg cover under the rail.
Passenger Seat
Passenger Seat Part 1:
Passenger Seat Part 2:
REMOVAL
When removing or installing the seat trim, handle it carefully to keep dirt out and avoid damage.
CAUTION:
- Before removing the front seat, turn the ignition switch off, disconnect both battery cables and wait and least 3 minutes.
- When checking the power seat circuit for continuity using a circuit tester, do not confuse its connector with the side air bag module connector. Such an error may cause the air bag to deploy.
- Do not drop, tilt, or bump the side air bag module while installing the seat. Always handle it with care.
- After front side air bag module inflates, front seatback assembly must be replaced.
- Some front seats are equipped with an Occupant Classification System sensor and control module. Do not disassemble front passenger seat cushion assembly or remove trim as this will affect the Occupant Classification System calibration.
- Always replace passenger seat cushion as an assembly if equipped with Occupant Classification System.
1. Slide the seat until the four body mounting bolts are visible and a tool can be inserted.
NOTE:
- When disassembling the driver seat after removal, set the front/rear cushion lifter to the top position.
2. Disconnect both battery cables and wait at least 3 minutes.
3. Remove the harness connector for the side air bag module.
4. Remove the four body mounting bolts and the seat belt anchor bolt.
To remove the seat belt anchor bolt, refer to "Removal and Installation of Front Seat Belt" .
5. Remove the power seat harness connector and vehicle harness fixing clip from the vehicle.
NOTE: When removing and installing, use shop cloths to protect the parts from damage where they may interfere with other parts.
INSTALLATION
- Install in the reverse order of removal.
NOTE: Be sure to insert the rear end tab of the rear leg cover under the rail.