Fill Procedures

FILL PROCEDURES




1. Fill procedures after installation of service part.
- Remove foam material remaining on vehicle side.
- Clean area in which foam was removed.
- Install service part.
- Insert nozzle into hole near fill area and fill foam material or fill in enough to close gap with the service part.

2. Fill procedures before installation of service part.
- Remove foam material remaining on vehicle side.
- Clean area in which foam was removed.




- Fill foam material on wheelhouse outer side.

NOTE: Fill in enough to close gap with service part while avoiding flange area.

- Install service part.

NOTE: Refer to label for information on working times.