Dashboard / Instrument Panel: Service and Repair

INSTRUMENT PANEL ASSEMBLY

Part 1:

Part 2:

Removal and Installation

Cluster Lid C
Pull lid toward rear of vehicle to release clips.




- Disconnect electrical connectors if equipped.

Installation is in the reverse order of removal.

Cluster Lid D
1. Remove cluster lid C. Refer to "Cluster Lid C".
2. Remove front air control.
- Remove screws using power tool.




3. Remove cluster lid D.
- Pull lid toward rear of vehicle to release clips.
- Disconnect electrical connectors.

Installation is in the reverse order of removal.

Instrument Lower Cover LH




1. Remove cluster lid C. Refer to "Cluster Lid C".
2. Remove fuse box cover.




3. Remove screws using power tool, and instrument lower cover LH.
- Pull toward rear of vehicle to release clips.
- Disconnect electrical connectors.

Installation is in the reverse order of removal.

Cluster Lid A




Pull up to release clips and remove cluster lid A.
Installation is in the reverse order of removal.

Combination Meter
1. Remove cluster lid A. Refer to "Cluster Lid A".




2. Remove screws from combination meter using power tool.
- Disconnect electrical connectors.
- Remove combination meter.

Installation is in the reverse order of removal.

A/T Finisher
1. Remove instrument lower cover LH. Refer to "Instrument Lower Cover LH".




2. Pull up to release clips and remove A/T finisher.
- Disconnect electrical connectors.

Installation is in the reverse order of removal.

M/T Finisher




1. Remove instrument lower cover LH. Refer to "Instrument Lower Cover LH".
2. Pull up to release clips and remove M/T finisher.
- Disconnect electrical connectors.

Installation is in the reverse order of removal.

Instrument Lower Cover RH and Glove Box




1. Remove screws from glove box striker and glove box using power tool.
2. Remove screws and remove glove box housing and glove box door.
- Remove glove box lamp and harness from glove box housing.
- Disconnect harness and remove trunk cancel switch.

3. Remove damper clip from glove box door.
4. Remove glove box pins and remove glove box door from glove box housing.
5. Remove screws and remove glove box latch.
6. Remove screws and remove glove box damper.

Installation is in the reverse order of removal.