Vehicle Does Not Creep Backward In "R" Position

Vehicle Does Not Creep Backward In "R" Position

SYMPTOM: The vehicle does not creep in the "R" position. Or an extreme lack of acceleration is observed.

DIAGNOSTIC PROCEDURE
1. CHECK A/T FLUID LEVEL
Check the A/T fluid level. Refer to "A/T FLUID CHECK".
OK or NG
OK >> GO TO 2.
NG >> Refill ATF.

2. CHECK CONTROL CABLE AND PNP SWITCH POSITION
Check the control cable and PNP switch position.
Refer to "Control Cable Adjustment".
OK or NG
OK >> GO TO 3.
NG >> Adjust control cable and PNP switch position. Refer to "Control Cable Adjustment" or "Park/Neutral Position (PNP) Switch Adjustment".

3. CHECK SELF-DIAGNOSTIC RESULTS
Perform self-diagnosis. Is any malfunction detected by self-diagnostic?
YES >> Check the malfunctioning system.
NO >> GO TO 4.

4. DETECT MALFUNCTIONING ITEM
1. Control valve assembly. Refer to "Control Valve Assembly".
2. Disassemble A/T. Refer to "DISASSEMBLY".
3. Check the items:
^ Forward and direct clutch assembly. Refer to "DISASSEMBLY".
^ 1st and reverse brake. Refer to "DISASSEMBLY".
^ B5 brake. Refer to "Transaxle Case Cover & B5 Brake".
^ Torque convertor. Refer to "DISASSEMBLY".
OK or NG
OK >> GO TO 5.
NG >> Repair or replace damaged parts.

5. CHECK TCM
1. Check TCM input/output signal. Refer to "TCM Input/Output Signal Reference Values".
2. If NG, recheck TCM pin terminals for damage or loose connection with harness connector.
OK or NG
OK >> GO TO 0.
NG >> Repair or replace damaged parts.

6. CHECK SYMPTOM
Check again.
OK or NG
OK >> INSPECTION END
NG >> Repair or replace damaged parts.